在线搜题网

在线搜题网

专业职业资格考试搜题

当前位置：首页＞翻译专业资格考试

题目内容:

[单项选择]

While it is essential that the text covers the sub

ject adequately, it is also important that it is neither too detailed or too complex for the intended reader.
A. for
B. nor
C. no
D. not

查看参考答案

更多"While it is essential that the text covers the sub"的相关试题:

[多项选择]Which of the following is not an essential prerequisite for AutoQoS to be correctly applied to an interface（）
A. The interface must be configured as a Multilink PPP interface.
B. The correct bandwidth should be configured on the interface.
C. A QoS policy must not be currently attached to the interface.
D. CEF must be enable
E. AutoQoS must be enabled globally before it can be enabled on the interface.
F. An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
[名词解释]分包（Sub-letting）
[判断题]End Sub是Sub过程的最后一条语句，它指出过程结束并返回到调用该过程的代码段。
[单项选择]While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?（）
A. ping
B. trace
C. show ip route
D. show interface
E. show cdp neighbors
[单项选择]While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist（）。
A. the session layer
B. the protocol layer
C. the data link layer
D. the access layer
E. the network layer
F. the application layer
[单项选择]Which options must you configure while performing an automated Tablespace Point-in-Time Recovery(TSPITR) by using Recovery Manager (RMAN)?（）
A. New channels for restore and recovery tasks
B. New name for the data files of the tablespace
C. Auxiliary name for the data files of the tablespace
D. Auxiliary destinations for an auxiliary set of data files
[多项选择] While troubleshooting connectivity issues, you log into a remote router. From there,you wish to see the layer 1 and layer 2 status of the interface. Which of the following IOS commands would you issue to check the current IP addressing, as well as theyer 1 and layer 2 status of an interface?（）
A. TK1# show version
B. TK1# show protocols
C. TK1# show interfaces
D. TK1# show controllers
E. TK1# show ip interface
F. TK1# show startup-config
[单项选择]While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?（）
A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer
[多项选择]While troubleshooting some connectivity issues，you issue the “show ip ospf database”in order to ex amine the link state database. Which three of the statements below are true regarding the OSPF link state database（）
A. Each router has an identical link state database.
B. External routes are imported into a separate link state database.
C. Syn chronization of link state databases is maintained via floodingo f LSAs.
D. Information in the link state database is used to build a routing table by calculating a shortest-path tree.
E. By default,link state databases are refreshede very 10 minutes in the absence of topology changes.
[单项选择]While troubleshooting a connectivity issue from a PC you obtain the following information: Local PC IP address: 10.0.0.35/24 Default Gateway: 10.0.0.1 Remote Sever: 10.5.75.250/24 You then conduct the following tests from the local PC: Ping 127.0.0.1 – Successful Ping 10.0.0.35 – Successful Ping 10.0.0.1 – Unsuccessful Ping 10.5.75.250 – Unsuccessful What is the underlying cause of this problem?（）
A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.
[多项选择] While troubleshooting an EIGRP routing problem you notice that one of the routers have generated a large number of SIA messages. What are two possible causes for EIGRP Stuck - In -Active routes?（）
A. Some quer y or reply packets are lost between the routers.
B. The neighboring router starts receiving route updates from this router.
C. A failure causes traffic on a link between two neighboring routers to flow in only one direction(unidirectional link).
D. Th e neighboring router stops receiving ACK packets from this router.
[填空题]若while循环的“头”为“while（i++<=10）”，并且i的初值为0，同时在循环体中不会修改i的值，则循环体将被重复执行（）次后正常结束。
[单项选择]程序代码：Text1.Text = "Visual Basic程序设计" 则Text1，Text ，和"Visual Basic程序设计"分别代表（）。
A. 对象，值，属性
B. 对象，方法，属性
C. 对象，属性，值
D. 属性，对象，值
[单项选择]Tape streaming is not happening while performing RMAN tape backup. On investigation, you find that it is not because of the incremental backup or the empty file backup and that RMAN is sending data blocks to the tape drive fast enough.What could be a solution to make tape streaming happen during the backup?（）
A. Configure backup optimization
B. Configure the channel to increase MAXOPENFILES
C. Configure the channel to increase the capacity with the RATE parameter
D. Configure the channel to adjust the tape buffer size with the BLKSIZE option
[单项选择] While performing a regular check on your recovery catalog you realized that the catalog database is running out of space and you do not have options to increase the space. However, you have another database where more space is available and you want to move your existing recovery catalog to this database. The options that can be considered while moving the recovery catalog are as follows:（） 1. Using one of the Oracle expdp utilities to export the catalog data 2. Creating a recovery catalog user and granting the necessary privileges in the other database 3. Creating the recovery catalog using the CREATE CATALOG command 4. Using the corresponding impdp utility to import the catalog data into the other database 5. Registering the target database in the new catalog database using the REGISTER DATABASE command Identify the option with the correct sequence for moving the recovery catalog.
A. 2, 3, 5
B. 1, 2, 4
C. 1, 2, 4, 5
D. 1, 2, 3, 4, 5
[多项选择]While troubleshooting a video problem on an application server, the system administrator has determined that the video firmware should be updated. Which of the following sources should be used to locate an appropriate update for this hardware?（）
A. Third-party manufacturer
B. Video chipset manufacturer
C. Server manufacturer
D. Operating system manufacturer
E. Shareware file sharing site
[多项选择]Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme?（）
A. statically map IPV4 address to IPV6 addresses
B. configuration IPv4 tunnels between IPV6 islands
C. use DHCPv6 to map IPV4 addresses to IPV6 addresses
D. use proxying and translation to translate IPV6 packets into IPV4 packets
E. configure IPV6 directly
F. enable dual-stack routing

推荐题目